Doc No. FM0816 issue 4 Page 18
24. USING THE I’M OK FUNCTION
The Advent XT2 system can be set to flash the green light and sound a double-beep every 20 seconds
on the
resident’s intercom unit during a preset time period each morning (
audible alert can be disabled).
If the resident is “up and about” and feeling OK they can press the I’M OK button on their intercom to stop the alert
and clear their room number from a list in the Advent XT2 memory.
The room numbers of the residents that HAVE NOT registered themselves OK can be viewed on the Manager’s Panel
and called by entering a special code on the telephone handset.
The I’m OK feature can be temporarily disabled by selecting Away Mode – see section 25 below.
CALL RESIDENTS THAT HAVE NOT RESPONDED I’M OK
1. Press the LINE key and enter 8 1
2. Wait for the “Ready” prompt in the earpiece
3. Enter the code 3000 followed by the key
4. The first room number that HAS NOT responded “I’m OK” will be heard in the earpiece
5. Press the key to speak to the resident
Press the 6 key to leave in the list and index to the next resident or
Press the 7 key to clear from the list then press 6 to index to the next resident
6. The next room number that HAS NOT responded “I’m OK” will be heard in the earpiece
7. Repeat as above then press the # key to end
8. Press the LINE key to clear the connection.
25. USING THE AWAY MODE FUNCTION
If I’m OK (or activity monitoring) is being used and the resident is going away for a day or more they should select
Away Mode on their intercom to prevent inactivity calls being signalled each day.
Press and hold the PRIVACY button to select away mode, when away mode is enabled a series of tones will sound and
the PRIVACY LED will be FLASHING AMBER. I’m OK and activity monitoring is now disabled, after a 5 minute exit time
Intruder Mode will automatically be enabled.
The room numbers of the residents that have Away Mode enabled can be viewed on the Manager’s Panel.
When the resident returns the Away Mode must be turned off to allow the I’m OK and activity monitoring features to
operate as normal again.
Press the PRIVACY button once to turn Away Mode off, a series of tones will sound and the amber privacy LED will
stop flashing.
If a resident fails to turn Away Mode back off when they return an intruder alarm call will be signalled
after a 5 minute entry time.
Door entry privacy mode is also enabled during away mode on door entry intercoms and the door
entry panel at the main entrance will indicate to visitors that the resident is not available.
26. USING THE INTRUDER FUNCTION
Individual residents can have their Activity Monitoring changed to an Intruder Mode if they are going to be away for a
prolonged period. Note: Intruder Mode is automatically enabled when an intercom is set to Away Mode.
Any movement detected in their room will report an “intruder alarm” call rather than simply logging the activity.
The room numbers of the residents that have Intruder Mode enabled can be viewed on the Manager’s Panel.
To Next Page
Loading...
