The Advent XT2 system has a local offsite facility to divert calls to a mobile Carer.
Answering a call in local offsite mode is identical to onsite mode except site identification is included in the message.
The procedure for cancelling a local offsite call differs slightly from the onsite mode procedure.
Local offsite mode can be enabled/disabled using a special code from the telephone. If disabled all alarm calls will be
reported in onsite or remote offsite mode only, mobile numbers will not be dialled.
ANSWERING A LOCAL OFFSITE CALL
1. Press the LINE key
2. Listen to the site ID and alarm message in the earpiece
3. Press the key to open speech
4. Speak to the resident, stop speaking to listen.
ENDING A LOCAL OFFSITE CALL
1. Press the # key once
2. Wait for the “Ready” prompt in the earpiece
3. Press the # key again
4. Wait for “2 Tones” in the earpiece
5. Press the LINE key.
MAKING A LOCAL OFFSITE CALL
1. Press the LINE key
2. Dial the site telephone number (inc. STD Code)
3. Wait for “2 Tones” in the earpiece.
4. When answered press the # key once.
5. Wait for the “Ready” prompt in the earpiece
6. Use the system as you would in onsite mode
7. End the call as described above.
LOCAL OFFSITE MODE ENABLE/DISABLE
1. Press the LINE key
2. Dial the site telephone number (inc. STD Code)
3. Wait for “2 Tones” in the earpiece.
4. When answered press the # key once.
5. Wait for the “Ready” prompt in the earpiece
6. Enter the code 5007 followed by the key
7. Local offsite mode enabled/disabled will be heard in the earpiece
8. Press the # key to toggle between enabled/disabled – the new mode will be heard in the earpiece
9. End the call as described above.
To Next Page
Loading...
