Doc No. FM0816 issue 4 Page 3
Read and understand these instructions before use.
Keep these instructions for future reference.
To reduce the risk of electric shock, do not disassemble this product.
Opening or removing covers may expose you to dangerous voltages or other hazards.
No user serviceable parts inside.
Refer all servicing to qualified service personnel.
This product should only be connected to a 220-240VAC 50/60Hz mains supply.
If you are unsure of the type of power supply consult your local power company.
Danger of explosion if the internal batteries are incorrectly replaced.
Use only manufacturer approved rechargeable batteries.
USB Ports are for Engineers use only – they are not suitable for charging Smartphones or Tablets.
This product should be located at least 2 metres away from other electronic equipment.
Failure to provide this separation may result in reduced radio range of Telecare products.
Do not expose to direct sunlight.
Do not expose to dripping or splashing water. As with any electronic equipment take care not to spill
liquids into any part of the system. Liquids can cause a failure and/or a fire hazard.
Clean with a hard-surface disinfectant wipe or a damp cloth and a non-abrasive cleaning product.
Polish with a dry duster. DO NOT use a wet cloth.
Avoid using harsh, abrasive or corrosive cleaning agents or detergents (e.g. scouring powders,
bleaches, polishes, etc.) when cleaning this product.
At the end of its life this product should be disposed of and recycled in accordance with the
environmental regulations. See the Regulatory Information in section 3 below.
To Next Page
