103
For your convenience, make the adjustments with the door open.
The driver’s seat in some motor vehicle congurations is
equipped with a lumbar support mechanism and seat height
adjustment.
Lever 4 for adjustment of the lumbar support is located on the
inner side surface of the backrest. Turning the lever forward or
backward results in a corresponding change of the convex sec-
tion in the lower part of the seat backrest, providing comfortable
support for the lumbar part of the spine.
In order to raise the driver’s seat, pull up handle 2 several times
until it is set to the desired height. To lower the driver’s seat, pull
down handle 2 several times until it is set to the desired height.
For your convenience, make the adjustments with the door open.
Rear triple seat (Fig. 3.33) consists of pillows and backrests
for one and two passengers.
Fig. 3.32. Front seat:
1 — catch for locking lateral movement of the seat; 2+ —
handle for adjusting the height of the driver seat airbag;
3 — handle for adjusting the tilt of the seat backrest; 4 —
handle for adjusting lumber support of driver seat airbag;
5 — headrest lock button
To Next Page
Loading...
