103
3. Turn on the power of the control box. After hearing the sound of "beep", it means
that the IP address of the control box has been reset successfully. The reset IP is
192.168.1.111.
4. Please unplug the cable connecting RI0 and GND and wait for the control box to
start up (60 seconds).
5. Enter 192.168.1.111 in the xArm Studio search box, connect the robotic arm.
6. If you need to modify the IP, just modify the IP in [Settings] → [System Settings]
→ [Network Settings].(For example: the modified IP is 192.168.1.135)
To Next Page
Loading...
