Ultimaker ORIGINAL+ - Page 4

4
6.4.2. Step 2: Assembling the Heated bed PCB 60
6.4.3. Step 3: Connecting the PCB to the Baseplate 62
6.4.4. Step 4: nishing the Z stage assembly 64
6.4.5. Step 5: installing the Z stage in the machine 67
6.4.7. Step 7: greas it up 69
6.5 Assemblingthematerialfeeder 70
6.5.1. Step 1: drive mechanism main body assembly 71
6.5.2. Step 2: drive bolt assembly 73
6.5.3. Step 3: clamp assembly 75
6.5.4. Step 4: attaching the feeder to the machine 80
6.5.5. Step 5: assemble the lament holder 80
6.6 Mountingtheelectronicscircuitboard 83
6.6.1. Step 1: mounting the electronic circuit board 84
6.6.2. Step 2: connecting the heater and Heated Bed 85
6.6.3. Step 3: connecting the print head electronics 87
6.6.4. Step 4: connecting the limit switches 87
6.6.5. Step 5: connecting the motors 87
6.6.6. Step 6: mounting the electronics cover 89
6.6.7. Step 7: strain relief 89
6.6.8. Step 8: Aligning the Z-stage 90
6.6.9. Step 9: checking and aligning the top-Z limit switch 90
6.7 AssemblingandconnectingtheUltiController 92
6.7.1. Step 1: assembling the UltiController 93
6.7.2. Step 2: connecting the controller 95
7 Usage of the Ultimaker Original+ 96
7.1 UsingtheUltimakerOriginal+forthersttime 96
7.1.1. Slicer software 97