Ultimaker ORIGINAL+ - Slicer Software

97
We recommend you to use supplied software, but feel free to use dierent
types of programs if you feel like you are up to it, or just simply disagree.
Playful experimenting and innovating is what made Ultimaking B.V. to what it is
today.
We also supply an Usermanual where you can nd a more detailed guide how
to handel the machine.
There are 2 dierent types of software that you will need to get your Ultimaker
printing. Some software have these combined, others do not.
First you need a slicer to create the le that containes all the parameters of a
print, called the Gcode. Secondly you need software to sent this Gcode to your
Ultimaker. In the beginning you most likely will download a le from the world
wide web to print. Plenty of these les can be found on websites like www.
youmagine.com.
One of the les that is printable is called a STL.
7.1.1. Slicer software
As a slicer we can recommend you to use:
-Cura
The basic idea of slicing is that it converts a printable le (STL) to a code that
contains all the information to create your print. We will take you along to
create a Gcode, to print with PLA.
Cura
1. Go to our website menu ‘community’
2. ‘download’ for the latest version of Cura.
3. Open Cura
4. Go to Expert > Install default Marlin Firmware.
5. Use the default STL
6. Go to Tools > Switch to Quickprint.
7. Choose High Quality Print, and PLA.
8. If asked, enter the diameter of your lament.
5 Notice: The lament should be approximately 2.85mm, but it may vary
0.7mm.
5 Notice: If you do not have digital calipers, enter a number between
2.85-2.90mm.
5 Notice: You do not have to tick ‘Print Support Structure’.