Ultimaker ORIGINAL+ - Page 98

Slicer software Using the Ultimaker Original+ for the rst time98
Is the Ultimaker Original+ connected with the computer, go to action 9.
If it’s not. Go to action 10.
Via the computer
9. If the Ultimaker is connected with the computer, click ‘Print’.
Via the UltiController
1. To print it with the UltiController, save your gcode to SD card for
example.
2. Place the SD card into the SD slot on the LEFT of your UltiController.
3. On the screen it should say, Card inserted.
4. Press the navigation wheel, go to card menu and select the le you
want to print.
5. Your Ultimaker will go ‘home’ heat up to the RIGHT temperature and
calculate a path and start to print.