Ultimaker ORIGINAL+ - Step 4: Preparing the BOTTOM Panel

Step 4: Preparing the BOTTOM panel Assembling the frame 19
6.1.4. Step 4: Preparing the BOTTOM panel
The following parts are needed in this step.
Letter Description Qnty.
A
BOTTOM panel 1
B
pieces of Velcro 4
C
bolts M3 x 10mm 4
1 x 1 x
4 x
4 x
image 12: parts needed for this step
To prepare the BOTTOM panel, perform the following actions:
1. Move 4 pieces black Velcro through the 4*2 slots of the
BOTTOMpanel, see image 14.
Make sure the soft side is facing itself after placing.
D
A B
C
E