Unify OpenScape 4000 - Bluetooth Settings; Activating and Deactivating Bluetooth; Changing the Bluetooth Name of Your Openscape CP700;700 X

Using Bluetooth 125
Bluetooth settings
Activating and deactivating Bluetooth
z You can also configure this setting via the Web interface  page 238.
@ Press the key for the Main menu if needed.
Open using the Softkey.
Open using the Softkey.
if nec. j Enter and confirm the User password.
Open using the Softkey.
Activate with the Softkey.
The Bluetooth function is activated and is now available.
A Bluetooth icon appears in the status bar.
Changing the Bluetooth name of your OpenScape
CP700/700X
Here you can determine which name your OpenScape CP700/700X should use
to register at other Bluetooth devices.
z You can also configure this setting via the Web interface  page 238.
@ Press the key for the Main menu if appropriate.
Open using the Softkey.
Open using the Softkey.
if nec. j Enter and confirm the User password.
Open using the Softkey.
Open using the Softkey.
ñ
The Bluetooth function was activated for your phone by the administrator.
Settings
_
$
User settings
-
_
$
Bluetooth
-
_
Enabled
¦_
„
Bluetooth on
By factory default, the Bluetooth name is: OpenScape CP700/700X.
If you are currently in the Bluetooth configuration, then the phone is visible.
If you exit the menu, it will be hidden again after a short time.
Settings
_
$
User settings
-
_
$
Bluetooth
-
_
Configuration
-
_