Unify OpenScape 4000 User Manual

Making calls 95
The subscriber is busy.
« Open the subscriber information.
End conference
Allowing call partners to continue a conference after you exit
Prerequisite: The function "Allow joining in a local conference" ( page 222)
was activated.
Press the Softkey.
or
] or É Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. Both call partners remain connected. You are disconnected from the con-
ference call.
Disconnecting a party
Press the Softkey. Both connections are cleared down – the conference is
cleared down.
Putting on hold and retrieving alternately or
simultaneously
Prerequisite: You are conducting a consultation call  page 91 or have accept-
ed a second call  page 97. You are in the call connection menu.
Putting an active call on hold
Ä Press the fixed Hold key.
or
Press the Softkey.
The consultation or second call and the first call are put on hold.
Retrieving the first call
^§ Press the key shown to switch to Conversations.
Select the Softkey to open the first call in the conversations list.
Press the Softkey. You are connected with the other party. The consultation or
second call continues on hold.
Retrieving the second call
^§ Press the key shown to switch to Conversations.
Select the Softkey to open the second call in the conversations list.
User
-
Exit conf.
P
_
End conf.
P
_
Hold
I
_
Andre-Marie Ampere
-
_
Reconnect
C
_
Daniel Bernoulli
-
_

Unify OpenScape 4000 Specifications

General

Brand	Unify
Model	OpenScape 4000
Category	Telephone
Language	English