Unify OpenScape 4000 - Dialing with the Selected Dialing Key; Dialing from Conversations

86 Making calls
Dialing with the selected dialing key
Via a permanently displayed programmable key in the left panel
When you press a selected dialing key, the associated contact or phone number
is displayed and the connection is set up.
Press the Function key for a saved number. The connection is set up.
From a connected OpenScape Key Module 600
When you press a selected dialing key, the associated contact or phone number
is displayed and the connection is set up.
You can program frequently used phone numbers on programmable keys
 page 136.
Press the Function key for a saved number. The connection is set up.
Via Favourites
@ Press the key for the Main menu if needed.
Open using the Softkey.
€ Select the Function key.
Press the Function key. The connection is set up.
Dialing from conversations
Depending on the configuration, the conversation list can contain data from the
following directories:
• Caller list
• Subscriber data from Exchange
• Subscriber data from the LDAP directory
If you cannot find redials or received or dialed calls in the list, check if the call
journal is activated.
The conversations list is displayed on the screen. If the contact you want is not
visible, then select with
μ€ or search by entering the phone number or name.
Confirm the selected contact with the Softkey. The phone number is dialed.
or
If visible, confirm immediately with the Softkey for the contact. The phone num-
ber is dialed.
_
O Party
Available
,
,
p Party O
_
Favourites
_
Party
O
_
Georg Simon Ohm
- O
_
Georg Simon Ohm
O
_