Unify OpenScape IP 35G SIP - Page 90

90 Enhanced phone functions
Allowing call waiting
z
You can also configure this setting via the WBM interface  Page 198.
Prerequisite: The option was programmed by your administrator.
Settings Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
if nec.j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Assuming Allow call waiting is generally activated, you can toggle the config-
ured sensor key to switch call waiting on/off ( Page 75).
If the Call waiting (second call) function is deactivated, a caller hears the
busy signal if you are already conducting a call.
Settings
User
Configuration
Incoming calls?
Handling? f
Allow call waiting = No f
Yes l
Save & Exit l