Unify OpenScape IP 35G SIP - Placing a Call on Hold

Enhanced phone functions 81
Placing a call on hold
You can use this function to place an ongoing call on hold, for instance, to pre-
vent the other party overhearing a conversation with a colleague in the same
room.
Prerequisite: You are conducting a call.
Select and confirm the option shown in the connections’s context menu.
or
Hold Press the Hold key. The key flashes.
Retrieving a held call
Select and confirm the option shown in the connections’s context menu.
or
Hold Press the flashing Hold key.
Using line keys
On multi-line telephones you can use the line keys to place ongoing calls on
hold.
R Press the corresponding line key. The line key LED starts flickering. The call is
now on hold.
Retrieving a held call:
T Press the corresponding line key. The line key LED lights up. The call is re-
trieved.
Hold ? f
If you do not retrieve the held call after a defined time interval, a reminder
beep sounds three times and a prompt to retrieve the call or disconnect
appears on the display. The settings for this can be found on
 Page 83
and  Page 84.
Reconnect ? l
The LED display  Page 17 indicates that the call is on hold to other multi-
line telephones where this line is also configured. These phones can then
pick up the call.