Universal Robots UR5e - Page 271

Regular TCP
Toolpath Moves
Similar to configuring a Remote TCP Toolpath Move, a regular TCP
Toolpath Move requires the following:
•
Toolpath file
•
Regular TCP
•
Plane Feature as a PCS
Configuring and
Importing a
Toolpath File
This is similar to configuring a Toolpath (see Configuring a Toolpath using
CAD/CAM Softwareon page266) and importing Toolpath (see Importing a
G-code Toolpath into PolyScopeon page266).
Configuring a
Regular TCP
•
Follow the instructions to configure a Regular TCP.
•
Verify the positive Z-axis of the tool points away from the part
surface.
UR5e 271 User Manual
Copyright © 2009–2023 by UniversalRobotsA/S. All rights reserved.