EasyManua.ls Logo

Universal Robots UR5e - Page 92

Universal Robots UR5e
364 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety
Function
Description PFH
D
Affects
Mode switch
INPUT
When the external connections are Low, Operation Mode
(running/ automatic operation in automatic mode) is in
effect. When High, mode is programming/ teach.
Recommendation: Use with an enabling device, for
example a UR e-Series Teach Pendant with an
integrated 3-position enabling device.
When in teach/program, initially the TCP speed will be
limited to 250mm/s. The speed can manually be
increased by using the pendant user interface “speed-
slider”, but upon activation of the enabling device, the
speed limitation will reset to 250mm/s.
Less
than
1.8E-07
Input to
SF2
Robot
Freedrive
INPUT
Recommendation: Use with 3PE TP and/or 3 Position
Enabling Device INPUT. When Freedrive INPUT is High,
the robot will only enter Freedrive if the following
conditions are satisfied:
3PE TP button is not pressed
3 Position Enabling Device INPUT either not
configured or not pressed (INPUT Low)
Less
than
1.8E-07
Input to
SF2
Robot
2.15.3. Table 2
UR e-Series robots comply with ISO 10218-1:2011 and the applicable portions of ISO/TS 15066. It
is important to note that most of ISO/TS 15066 is directed towards the integrator and not the robot
manufacturer. ISO 10218-1:2011, clause 5.10 collaborative operation details 4 collaborative
operation techniques as explained below. It is very important to understand that collaborative
operation is of the APPLICATION when in AUTOMATIC mode.
# ISO 10218-1 Technique Explanation UR e-Series
1
Collaborative
Operation 2011
edition, clause
5.10.2
Safety-rated
monitored
stop
Stop condition where position is
held at a standstill and is
monitored as a safety function.
Category 2 stop is permitted to
auto reset. In the case of
resetting and restarting
operation after a safety -rated
monitored stop, see ISO 10218-
2 and ISO/TS 15066 as
resumption shall not cause
hazardous conditions.
UR robots’ safeguard
stop is a safety-rated
monitored stop, See
SF2 on page 1. It is
likely, in the future, that
“safety-rated monitored
stop” will not be called a
form of collaborative
operation.
User Manual UR5e
Copyright © 2009–2023 by UniversalRobotsA/S. All rights reserved.

Table of Contents

Other manuals for Universal Robots UR5e

Related product manuals