Start-up
22
5.3 Unpacking
Required tools: Knife / cutter
Carry out the following steps to unpack:
1. Carefully cut the packaging foil and remove it.
2. Cut open and remove the lashing straps and cable ties.
3. Check the inflation pressure of the tyres and pump up as necessary.
4. Tilt the "Milk Shuttle" slightly over one of the rear wheels and remove the
transport block
➌ under the wheel axle as far as possible.
5. Tilt the Milk Shuttle slightly over the other rear wheel and remove the transport
block
➌ completely.
CAUTION
The "Milk Shuttle" must be lifted to be unpacked. Therefore, always include a
second person to help unpack.
CAUTION
Figure 5/1: Unpacking
To Next Page
Loading...