Programming and calibrating
43
7 Programming and calibrating
7.1 General settings
Switch on the Milk Shuttle with the key (approx. 2 seconds).
The device is in standby mode and shows
the start display:
The functions described in this chapter are accessed by pressing and
holding the key.
In this menu you can change the settings for the
•Time
•Date
• Language
• Temperature unit and
• Temperature warning level
and have the serial numbers and version numbers displayed.
Use the / keys to scroll through the menus.
7.1.1 Setting the time and date
The clock must be changed manually from summertime to wintertime. The
seconds cannot be set. To change the time and date, carry out the following
steps:
1. Press the key for approx. 2 seconds. The display
shows the date and time:
2. Briefly press the key:
3. Use / to the change the hours.
Information
In this chapter you will use the programming mode.
You can recognize this programming mode in that the values to be programmed
(the warning temperature here), are set in angle brackets:
Temp. Warning level
max > 45.0 C<
16.07.14 10:30:32
MilkShuttle 105A31
-
Date Time
08.04.14 10:30:32
To Next Page
Loading...
Need help?
General