Programming and calibrating
54
3. Press (approx. 1 second) to switch to the
programming mode:
4. Press / to set the required feed
amount (here: 3.5 l (or kg)):
5. Briefly press the key.
6. This assigns the preselection key a feed amount of 3.5 l (or kg) and ends
the programming mode.
Use the key to exit the programming of the feed amount.
7.5 Programming the cleaning programs
The preselection keys , and can be programmed with frequently
required cleaning times. One can either programme simple or extended cleaning
programs. With extended cleaning, the rinsing phase is preceded by a heating
phase. While simple cleaning is possible both in mains and in battery mode, the
extended cleaning (with pre-heating function) is only possible in mains operation.
Switch on the Milk Shuttle with the key
(approx. 2 seconds).
The "Cleaning" menu is accessed from the main menu:
Hold down the key for approx. 2 seconds.
After pressing the key, the LED of this key flashes. The last used cleaning
menu is called up.
The factory settings for the cleaning times are as follows:
- Key 1: 2 minutes
- Key 2: 3 minutes
- Key 3: 5 minutes
In the following example, the preselection key is programmed for a cleaning
time of 4 minutes:
1. Hold down the key for approx. 2 seconds.
2. Briefly press the key:
-
15.07.14 10:30:32
MilkShuttle 105A31
To Next Page
Loading...
Need help?
General