Operation
34
6.3 Feeding
6.3.1 Removing/dosing feed
6.3.1.1 Manual removal
1. Open the lid closures of the feed container.
2. Place an appropriate container underneath the outlet.
3. Open the drain valve by moving the valve lever in the direction of the arrow.
4. Remove the required feed amount.
5. Close the drain valve by moving the valve lever against the direction of the
arrow.
Information
The container lid is well sealed. This prevents the feed from spilling during
transport.
Before feeding, open the snap closures of the container lid to prevent negative
pressure from developing in the container during feeding.
Information
After starting up, the feeding function must be first calibrated to the required unit
(litre or kilogram) (see chapter 7.2.1, page 46 or chapter 7.2.2, page 47).
Otherwise, the required feed amount can deviate considerably from the set
value.
Figure 6/2: Manually removing the feed
To Next Page
Loading...
Need help?
General