Urban MilkShuttle - 7.3.2 Operating Values

Programming and calibrating
50
Switch on the Milk Shuttle with the key (approx. 2 seconds).
The "Heating and Agitating" menu is accessed
from the main menu:
Hold down the key for approx. 2 seconds.
7.3.2 Operating values
Three values can be programmed in the heater control:
• Target temperature of the heater
• Operating time of the mixer
• Break time of the mixer
The following values are preset when delivered:
• Target temperature: 40 °C
• Agitating: 10 seconds
• Break: 15 seconds
The following example describes how to program with values:
• Target temperature: 38 °C
• Agitating: 20 seconds
• Break: 45 seconds
To do so, carry out the following steps:
1. Hold
down the
key for approx. 2 seconds.
2. If no start times are programmed, you will briefly
see this displa
y:
The display
then switches automatically:
3.
Press
to switch to the programming mode:
4.
Press the
key again:
5.
Press
/ to set the required target
amount (38 °C):
6. Briefly pr
ess the
key.
ON
16.07.14 10:30:32
MilkShuttle 105A31
°C/F
°C/F
1:Automatic Heating
1:--:-- active
Heating Agitating
16.3 C 00:28
40.0 C
Break
16.3 C 00:28
blinking
1 sec
SET
SET Target
40.0 C
SET
SET Target
>40.0 C<
+
-
SET Target
> 38.0 C<
SET
SET Target
38.0 C