Operation
33
3. Press the key for approx. 2 seconds.
4. Start the agitator at Level I (slow mode).
5. Heat the feed to a temperature that is approx. 5°C above the recommended
feeding temperature,
e.g.: required feeding temperature 38°C -->heat to 43°C
6. Once the required temperature is reached:
Set the agitator to Level II (fast mode) and briefly press the key on the
operating panel to start long-term operation of the agitator.
7. Slowly add the required amount of calf milk replacer (CMR).
8. Then add the remaining amount of water.
9. Wait until the required temperature is reached, as necessary.
10. Serve the feed immediately.
11. Then start the cleaning program (see chapter 6.4, page 37).
6.2.1.2 Fill whole milk
1. Fill the required amount of whole milk.
2. Press the key on the operating panel for approx. 2 seconds to
switch on the control. The displays shows the
start window:
3. Press the key for approx. 2 seconds.
4. Start the agitator in interval mode at Level I (slow mode).
5. Heat the feed to the required temperature.
6. Serve the whole milk immediately.
Then start the cleaning program (see chapter 6.4, page 37).
Information
The heating phase can be potentially omitted if using hot water for mixing.
16.07.14 10:30:32
MilkShuttle 105A31
To Next Page
Loading...
Need help?
General