Operation
31
Operation/Standby
After switching on, the control for the heater and
the agitator is in standby mode at first. The
start display is shown:
This prevents the heater and agitator from running when the feed container is
empty.
After filling with whole milk or water, press the key (approx. 2 seconds) to
switch on the heating control.
Briefly pressing the key switches the control back to the "Standby" operating
mode.
Before the start, the Heating/Agitating function checks if times are programmed
under "Start time 1". If no start time is programmed, the Milk Shuttle briefly
displays the following menu and begins to heat and agitate after one or two
seconds:
If Start time 1 is programmed, the Milk Shuttle begins to heat/agitate at 3:30 p.m.,
exactly in 2 hours and 12 seconds:
The heater begins to heat the feed to the set temperature.
The agitator runs at the set operating and pause times.
Briefly pressing the key lets you start heating/agitating before the set start
time.
The display alternately shows the target temperature, actual temperature and the
agitating time:
Once the agitating time has expired, the display alternately shows the break time:
Information
Always adapt the speed of the agitator to the type of feed you use:
Slow (Level I): whole milk, heating phase
Fast (Level II): concentrated milk powder, heating phase
16.07.14 10:30:32
MilkShuttle 105A31
1:Automatic Heating
1:--:-- active
1:Automatic Heating
1:Start in --:--:--
1:Automatic Heating
1:15:30 active
1:Automatic Heating
1:Start in 02:00:12
Heating Agitating
16.3 C 00:28
40.0 C Agitating
16.3 C 00:28
Heating Break
16.3 C 00:28
To Next Page
Loading...
Need help?
General