Maintenance/Repairs
75
Correctly insert new battery ➋ (negative pole of battery at spring bracket ➌ of the
battery holder).
First position the battery at a slight angle up to the bottom stop of the battery
holder and then press into the final position.
4. Close the control housing.
5. Switch on the device.
6. Set the date and time (see chapter 7.1.1)
Figure 9/9: Insert battery for date/time
Information
• The entered feeding data of the last 24 hours may have been lost due to
the battery replacement. When recommissioning the Milk Shuttle, check
the settings in the display. Older feeding data are retained.
• Dispose of spent batteries according to the applicable local provisions.
To Next Page
Loading...
Need help?
General