USTER®
HVI 1000
Instruction Manual
Uster Technologies, Inc. Chapter 3
(3/08) System Startup - Page 3-10
3.1 Configuration
Important operating parameters are defined here. Normally, these
choices are made at system startup and retained indefinitely. This menu
includes numerous choices for setting up the instrument for system
testing.
Configuration must be performed before calibration, system testing, or
module testing can begin. When the CONFIGURATION icon is selected,
a valid password must be entered to display the CONFIGURATION MENU
in the Action area. The following selections are available:
♦ Test Setup
♦ Lot Limits
♦ Side Limits
♦ HVI Offsets
♦ Diagnostics Log
♦ Report Setup
♦ Data Alarms
Note: Refer to the Configuration chapter for detailed information on
these procedures.
To Next Page
Loading...
