USTER HVI 1000 - 3.2 Calibration

USTER® HVI 1000 Instruction Manual
Uster Technologies, Inc. Chapter 3
(3/08) System Startup - Page 3-11
3.2 Calibration
Calibration or calibration checks are routine procedures normally
performed at the start of a shift. When the C
ALIBRATION icon is
selected, the C
ALIBRATION MENU is displayed. Some items require a
supervisor password.
The CALIBRATION MENU allows you to check calibration, setup tolerances,
setup references, and view calibration results for the following:
♦ Length/Strength
♦ L/S Cotton
♦ Micronaire
♦ MIC Cotton
♦ Color/Trash
♦ Color Tiles
♦ Trash Tiles
Note: Refer to the Calibration chapter for detailed information on
these procedures.