USTER HVI 1000 - Page 96

USTER® HVI 1000 Instruction Manual
Uster Technologies, Inc. Chapter 6
(3/08) System Testing - Page 6-2
The upper portion of the Sample Testing area reflects the status of items
set in the CONFIGURATION MENU. These items include:
1. Number of Length/Strength tests to be performed.
2. Number of Micronaire tests to be performed.
3. Number of Color/Trash tests to be performed.
4. Host communications (On/Off)
5. Apply Side Limits (Yes/No)
6. Allow Manual Mic Entry (Yes/No)
7. Lot Limits (dialog)
To change any of these items, go to Configuration and select the TEST
SETUP tab.
Note: The Lot Limits dialog will be blank when lot limits are not in use.
If lot limits are being used, the dialog box will contain the name of the
lot limit set.
The following information can be entered prior to testing:
1. Allow Manual Mic Entry (Mode 3 and Mode 4)
2. Lot ID
3. Operator ID
4. Bale Group
Once all information has been correctly entered, click the Start
Testing button to launch the SYSTEM TESTING MENU.