UTECH VS2000 User Manual

Chapter 13: Maintenance and Troubleshooting
VS2000 Vital Signs Monitor Operation Manual 13-1
Chapter 13: Maintenance and Troubleshooting
The products have been designed to operate continuously for long periods
without maintenance.
However, in order to ensure a continued high level of performance and safety
of operation, you must observe the routine maintenance information in this
section.
Perform on-site routine maintenance daily; a summarized schedule and full
details are contained in this section.
The Vital Signs Monitor Service Manual also contains the circuit diagrams,
parts lists, and descriptions required for carrying out repairs and disposing of
batteries. The Service Manual is available on request from Utech Co., Ltd. or
your local agent.
MAINTENANCE ITEM RECOMMENDED MAINTENANCE INTERVAL
Monitor surfaces
Clean and/or disinfect
As required (See this page for
instructions)
ECG cables
Clean and/or disinfect
Inspect for signs of damage
or deterioration; replace as
required.
Daily
Daily
ECG electrodes
Clean and/or disinfect
When attaching a new
patient
SpO2 sensor
Clean and/or disinfect
When attaching a new
patient
NIBP cuff and hose
Clean and/or disinfect
Inspect for signs of damage
or deterioration; replace as
required.
When attaching a new
patient
Daily
TEMP sensor
Clean and/or disinfect
When attaching a new
patient
CAUTION! Follow local governing ordinances and recycling instructions
regarding disposal and recycling of device components.
13.1 Cleaning the Monitor's Surfaces

UTECH VS2000 Specifications

General

Brand	UTECH
Model	VS2000
Category	Monitor
Language	English