To Next Page

To Previous Page

Chapter 9: Non-invasive Blood Pressure

9-6 VS2000 Vital Signs Monitor Operation Manual

2. Turn the rotary knob to choose a test mode (AUTO, MANUAL, or STAT), and

push the knob to select.

•If you choose AUTO or STAT, the selected mode will be displayed in the

parameter box.

9.6 Adjusting the Settings in the Parameter Box

9.6.1 NIBP Alarm Setup

1. Turn Alarm Detection On or Off

You can turn on or off the alarm detection capability for each of the NIBP

measured values (SYS, DIA, and MAP). If SYS ALARMS is on, an alarm will be

issued when the high or low alarm limit for systolic pressure is violated,

regardless of which set of alarm limits is displayed. If you turn SYS ALARMS off

and the high or low alarm limit is violated, an alarm will not be issued. When

you turn off the monitor and turn it on again, [SYS, DIA, or MAP] ALARMS will

be reset to ON; the default setting for each pressure value is ON.

Figure 9.3: NIBP Alarm Setup

To turn on or off the alarm detection for each pressure value (SYS, DIA and

MAP):

a) Push and Turn the rotary knob on the monitor to move the cursor. Highlight

the NIBP parameter box and push the knob to access the NIBP parameter

menu.

b) Highlight NIBP ALARM and push the knob to access the alarms submenu.

c) Choose each pressure value (SYS, DIA, and MAP) and choose ON or OFF for

each one. Push the knob to select.

UTECH VS2000 User Manual

Questions and Answers: