Chapter 13: Maintenance and Troubleshooting
VS2000 Vital Signs Monitor Operation Manual 13-5
13.4.2 Back to Factory Default Values
You can set up your monitor to operate using the default values you choose
for alarm limits, volume, LCD brightness, parameter settings.
Figure 13.1: Factory Default Values
1. Press the menu key to pop up the main menu and turn the rotary knob to
move the cursor to the “Maintenance” option.
2. Push the rotary knob to access the “Maintenance” submenu and choose
“Machine” option. Turn the knob to highlight the “Factory Default” option.
3. Push the rotary knob to access the factory default submenu and turn the
knob to “OK” and push it if you want to restore the factory settings.
13.4.3 Using the Demo Mode
This demo mode is intended for service personnel. Contact your authorized
repair center for help.
WARNING! While the demo mode is active, no patient data is collected or
analyzed. Never attach a patient to the monitor while it is in
demo mode.
The monitor includes a demonstration mode to be used for training and sales
activities. Installed parameters are simulated when the demo mode is turned
on. All of the functions of the monitor will be simulated in the demo mode,
including alarms, trends, and NIBP history.
To Next Page
Loading...
Need help?
General
