Vacon 10 - Page 50

control panel vacon • 47
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
7.4.5 System menu
SYS menu including fault submenu and system parameter submenu, and the display
and operation of the system parameter submenu is similar to PAR menu or MON
menu.In system parameter submenu, there are some editable parameter (P) and
some uneditable parameter (V).
The Fault submenu of SYS menu includes active fault submenu and fault history sub-
menu.
Figure 7.6: Fault menu
In active fault situation, FAULT arrow is blinking and the display is blinking active
fault menu item with fault code. If there are several active faults, you can check it by
entering the active fault submenu F5.x. F5.1 is always the latest active fault code. The
active faults can be reset by pressing BACK / RESET button with long time (>2 s),
when the API is in active fault submenu level (F5.x). If the fault cannot be reset, the
blinking continues. It is possible to select other display menus during active fault, but
in this case the display returns automatically to the fault menu if no button is pressed
in 10 seconds. The fault code, subcode and the operating day, hour and minute val-
ues at the fault instant are shown in the value menu (operating hours = displayed
reading).
OK
Press OK to enter V1.1
1
Press Left/Right button
to browse other groups
2
Press down to browse
other active faults
3
REF
MON
PA R
SYS
FAULTALARMSTOP
FWD REV I/O KEYPAD BUS
READY RU N
OK
Press OK to select one fault
to browse its time
4
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS
Browse for fault code(C xx),
subcode(Id xx), days(d xx),
hours(H xx), minutes(M xx)
5
REF
MON
PA R
SYS
FAU LTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS
REF
MON
PA R
SYS
FAULTALARMSTOPREADY RUN
FWD REV I/O KEYPAD BUS