Vacon 10 User Manual

control panel vacon • 41
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
7
7.4 Navigation on the Vacon 10 control panel
This chapter provides you with information on navigating the menus on Vacon 10 and
editing the values of the parameters.
7.4.1 Main menu
The menu structure of Vacon 10 control software consists of a main menu and sev-
eral submenus. Navigation in the main menu is shown below:
Figure 7.2: The main menu of Vacon 10
FWD REV I/O KEYPAD BUS
REF
MON
PA R
SYS SYS
SYS SYS
SYS SYS
SYS SYS
FAULTALARMSTOPREADY RU N
FWD REV I/O KEYPAD BU S
REF
PA R
FAU LTALARMSTOPREADY RUN
MON
FWD REV I/O KEY PAD BUS
REF
PAR
FAU LTALARMSTO PREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAULTALARMSTOPREADY RUN
MON
FWD REV I/O KEYPAD BUS
REF
PAR
FAU LTALARMSTO PREADY RUN
MON
PRESS
PRESS
PRESS
PRESS
PRESS
FWD REV I/O KEYPAD BUS
REF
MON
PA R
FAULTALARMSTOPREADY R UN
PRESS
PRESS
OK
OK
OK
OK
OK
In this menu
you can
browse the
monitoring
values.
In this menu
you can
browse and
edit the
parameters.
Dispalys the
keypad reference
value
regardless of
the selected
contron place.
Here you will be
able to browse
system parameter
and fault
submenu.
MONITORING
MENU
REFERENCE
MENU
PA RA M E T ER
MENU
SYSTEM
MENU
Hz
Hz

Vacon 10 Specifications

General

Brand	Vacon
Model	10
Category	Controller
Language	English