VAF instruments OILCON MARK 6M - 18.2 SYMBOL LIST; 19 SPARE PARTS; 19.1 STANDARD SPARES

175 pages

Save Page as PDF

To Next Page

To Previous Page

168

18 ABBREVIATIONS

18.1 ABBREVIATIONS

ATF Automatic Transmission Fluid

CCR Cargo Control Room

DPT Differential Pressure Transmitter

EPU Electro Pneumatic Unit

GPS Global Position System

IMO International Maritime Organization

IOM Installation, Operation and Maintenance

MCU Main Control Unit

NO Normally Open

NC Normally Closed

MCT Multi Cable Transit

I/S signal cable Intrinsically safe signal cable

18.2 SYMBOL LIST

Main Page

Default Chapter2
- Table of Contents2
1 Preface7
- General7
- Symbols8
- Copyright8
2 Product Description9
- Principle of Operation9
- Product Configuration10
- Sampling System Arrangements13
3 Technical Specification15
- General15
- Main Control Unit (MCU)15
- Electro Pneumatic Unit (EPU)16
- Skid17
- Sample Pump17
- Reference Table of Products Which May be Measured18
- Biofuel Guidelines and Definitions19
4 Safety Instructions20
- Safety Precautions20
5 Unpacking21
6 Installation23
- Introduction23
- Utilities23
- Pipework General24
- Bulkhead Penetrations General30
- Electrical Installation General32
  - Electro Pneumatic Unit (EPU)32
  - Starter Box33
- Control Room Equipment - Main Control Unit (MCU)33
  - Speed Input33
  - Overboard Valve Control33
- Installation Checklist34
- Overview Installation Check38
7 Operating Instructions44
- Layout of the MCU44
- Operating the MCU and Menu Layout46
  - Standby Mode (Menu 1)48
- Short Reference Guide for Operating the MCU66
  - Discharging Ballast Water66
  - Shutdown of Discharging Operations68
- Miscellaneous69
  - Oil Content Reading Higher than Expected69
  - Oil Level Alarm69
- Operational Alarms70
- System Failures71
  - Auto/Manual Operation71
- System Overrides73
8 Maintenance75
- Maintenance General75
- Routine Maintenance76
- Test and Check-Out Procedure78
9 Repair or Replacement85
- Detector Cell85
  - Removing the Detector Cell85
  - Reinstalling the Detector Cell85
- Window Wash Pump86
- Sample Pump87
  - Disassembling the Pump/Motor87
  - Reassembling the Pump/Motor88
- Differential Pressure Transmitter - FUJI89
  - Zero Adjustment of DPT - FUJI89
  - Span Adjustment of DPT - FUJI89
- Differential Pressure Transmitter - ABB90
  - Zero Adjustment of DPT - ABB90
  - Span Adjustment of DPT - ABB90
14 Disposal91
10 Take out of Service91
11 Removal and Storage of Equipment91
12 Malfunction and Send for Repair91
13 Environment91
15 Trouble Shooting and Fault Finding92
- Introduction Fault Finding Guide92
- Fault Finding Guide93
- Calibration Alarms95
  - Zero Error Alarm95
  - Path Dirty Alarm96
- System Alarms97
- GPS Problems99
  - No GPS Signal Visible99
- Power Supply Problems100
  - MCU Power Failure100
  - Electro Pneumatic Unit Power Failure100
- Air Supply Problems101
  - Air Supply Failure101
  - Water Found in the Monitors of the Air System101
- Solenoid Valve Problems101
  - Valve Not Working101
- Pneumatic Valve Problems102
- Window Wash Pump Problems103
- Sample Pump Problems104
  - Electrical Problems104
    - Pump Runs but the Green Indicator on the Starter Box Is off104
    - Pump Should be Running but Is off104
  - Pump Related Problems104
    - No Flow105
- Differential Pressure Transmitter Problems106
- Fault Finding Form107
16 Certificates111
- Certificates of Ex-Proof111
- Certificates of Type Approval126
17 Drawings127
18 Abbreviations169
19 Spare Parts170
20 Warranty Conditions172

VAF instruments OILCON MARK 6M - 18.2 SYMBOL LIST; 19 SPARE PARTS; 19.1 STANDARD SPARES

Table of Contents