VAF instruments OILCON MARK 6M - Data Mode (Menu 1.3)

51
7.2.1.3 Data mode (menu 1.3)
The data mode is entered when the <DATA> key is pressed in the menu 1.
The mode is used to print out logged data with a printer or copy this data to a USB flash drive.
In the data mode a selection has to be made whether the data is printed to a printer or copied to a
USB flash drive.
Figure 40
When a selection has been made, two dates in either menu 1.3.1 or menu 1.3.2 have to be set to
mark the begin date and end date of the logged data to be printed or copied.
The data format used is DD – mm – YYYY.
Figure 41
During the printing or copying no keys are available on the display. When the printing or copying
has finished, the keys will reappear.
Figure 42
CONTROL Sample point: 1 22-11-11
data Oil type: 5 10:38
USBPRINTERBACK
CONTROL Sample point: 1 22-11-11
data Oil type: 5 10:38
Start: 07 - 10 - 2011
End: 22 - 11 - 2011
BACK
-
NXT
PRV
+
OK
CONTROL Sample point: 1 22-11-11
data Oil type: 5 10:38
2011/11/dat07.bin - processing - copied
2011/11/dat08.bin - processing - copied
2011/11/dat10.bin - processing - copied
2011/11/dat16.bin - processing - copied
2011/11/dat17.bin - processing - copied
2011/11/dat21.bin - processing - copied
USBPRINTERBACK