75
8.2 ROUTINE MAINTENANCE
There is little routine maintenance that can be carried out on the Oilcon
®
Oil Discharge Monitoring
and Control System. The major requirement is to ensure that the lubricator in the system is kept
topped up and a regular check of the air regulator housings for excess water.
8.2.1 Sample pump/motor lubricator
The sealing device of the sample pump requires no maintenance or adjustment. When a new seal is
being run in, small leakage may occur momentarily.
If any water leakage occurs, this will drip out of the 2 mm keyway at the bottom side of the pump
casing, visible from the pump room side.
Proper functioning of the gas seal located in the centre of the pump main plate relies on the
presence of oil for lubricating, sealing and cooling purposes.
The oil reservoir shall always be sufficiently filled with oil. It can easily be filled by opening the
spring-loaded cap on top, and pouring the oil in.
There is no need to disassemble any part of the support assembly.
For lubricating oil to use of a light duty type of machine oil is recommended, or Automatic
Transmission Fluid.
The viscosity of the oil must be within the range of:
20 – 100 cSt
20 – 100 cPs
100 – 500 SSU
3 – 14° Engler
Suggested products are:
Machine oil Automatic Transmission Fluid
AGIP OSO 22 or 32 AGIP ATF 2D
Castrol MLV30
Castrol Highspin AWH-- M68
Elf Olma DS 46 Elf Transomatic
Elf Hydrelf DS 46
Esso Teresso 32 or 46 Esso ATF-D
Esso Nuto-H 32 or 46
Kroon Carsinus U68 Kroon Almurol
Kroon Abacod MEP 68
Kroon Perlus AF
Pennzoil AW Hydraulic 22 or 32 Pennzoil ATF
Pennzoil Pennzgear 150 or 220
Shell Tellus 22 or 37 Shell Donax TA
Total Azolla ZS 32 Total Fluïde ATX
Total Preslia 32
Texaco ISO VG 32 or 68 Texaco Texamatic 4261
Biodegradable:
Castrol Carelube SES32
WARNING:
ATF-TYPES OF OIL ARE NOT TO BE MIXED WITH GENERAL MACHINE OIL.
To Next Page
Loading...