VAF instruments OILCON MARK 6M - Manual Flush Mode (Menu 1.5.3.5.3); Manual Window Wash Mode (Menu 1.5.3.5.4)

63
7.2.1.5.4.5.3 Manual flush mode (menu 1.5.3.5.3)
The manual flush mode is entered when the <FLUSH> key is pressed in menu 1.5.3.5
After the <FLUSH> key is pressed, the system initiates a manual flush sequence.
The sequence consists of approximately 12 seconds window wash and a total of 3 minute forward
flush and calibration. After completion of the flush sequence and if no failures are detected the
system will continue the discharge operation.
During the manual flush the ballast water is diverted to the slop tank instead of being discharged
overboard.
Figure 56
During the flush sequence no keys are available on the display. When the sequence has finished,
the keys will reappear.
7.2.1.5.4.5.4 Manual window wash mode (menu 1.5.3.5.4)
The manual window wash mode is entered when the <W WASH> key is pressed in menu 1.5.3.5.
After the <W WASH> key is pressed, the system initiates a manual windows wash sequence to
keep the detector cell in an optimal condition.
The sequence consists of approximately 12 seconds window wash.
During the manual window wash the ballast water continues to be discharged overboard.
Figure 57
During the window wash sequence no keys are available on the display. When the sequence has
finished, the keys will reappear.
CONTROL Sample point: 1 22-11-11
manual flush Oil type: 5 10:38
Concentration A 0 PPM discharge
Flow A 0 m3/h dirty
Skid Flow 0 l/h com: C
Speed A 10.0 kts pos: C
Discharge rate 0 l/nm s egregated
Total oil 2.1 l com: C
Latitude 5321.756N pos: C
Longitude 00711.854E
Forward flush
EPU: OK
free: 1927296 kB
CONTROL Sample point: 1 22-11-11
window wash Oil type: 5 10:38
Concentration A 200 PPM discharge
Flow A 165 m3/h dirty
Skid Flow 0 l/h com: O
Speed A 10.0 kts pos: O
Discharge rate 3.3 l/nm segregated
Total oil 2.1 l com: C
Latitude 5321.756N pos: C
Longitude 00711.854E
EPU: OK
free: 1927296 kB