19
4 SAFETY INSTRUCTIONS
4.1 SAFETY PRECAUTIONS
All precautions have been taken to ensure, in so far as reasonable practical, that the equipment has
been designed and constructed to be safe and without risk to health or the environment when
properly used.
Provided that the recommendations contained in this manual are carefully adhered to, no
circumstances are foreseen where the equipment will present a health or safety hazard.
To ensure the safety of personnel, equipment and the environment:
Always follow the safety, installation, repair and maintenance recommendations in this
manual.
All personnel who installs, operates, repairs or maintains the equipment should read this
manual completely and make themselves acquainted with the equipment before installing,
operating, repairing or maintaining the equipment.
Make sure that all safety requirements are met before installing, operating, repairing or
maintaining the equipment.
Always use personal protective means when necessary.
Always use the adequate tools to perform the work.
Make sure that all equipment is isolated from the electrical-, water and air supplies before
installing, repairing or maintaining the equipment.
Never assemble or disassemble electrical equipment or remove or install printed circuit
boards with power switched ON.
Always handle printed circuit boards with CMOS components according to the correct
procedures for such components, to prevent any damage due to electrostatic discharges.
Only use cleaning solvents in a well ventilated area. Avoid breathing fumes. Keep away from
open fire. Do not use solvents on plastic components or parts.
To Next Page
Loading...