VAF instruments OILCON MARK 6M - Setup Mode (Menu 1.5.2)

55
7.2.1.5.2 Setup mode (menu 1.5.2)
The setup mode is entered when the <CHANGE> key is pressed in the menu 1.5.2.
In order to setup the system for a specific ballast water discharge, it is necessary to enter specific
parameter settings.
In the setup mode the settings can be changed by either entering a numeric value or by selecting a
preset value. Different preset values can be selected by pressing < + > or < - >.
Selecting a different setting is done by pressing the <PRV> or <NXT> key and thereby scrolling
through the different settings.
Figure 45
By pressing the <CLR> key the value is cleared after which the setting can be entered.
When the <PRV> or <NXT> key is pressed, the previous or next setting is selected and value
entered in the current menu is automatically stored.
Figure 46
CONTROL Sample point: 1 22-11-11
setup Oil type: 5 10:38
sample point
discharge mode
total oil limit
reset total oil
discharge alarm
speed ind. 1 port high
flowrate ind.
oil type
conc. alarm
printing interval
oil conc. ind.
display contrast
date / time
OK
-
NXT
PRV
+
CONTROL Sample point: 1 22-11-11
setup Oil type: 5 10:38
sample point
discharge mode
total oil limit
reset total oil
discharge alarm
speed ind. 30 l
flowrate ind.
oil type
conc. alarm
printing interval
oil conc. ind.
display contrast
date / time
OK
32
1
0
65
4
CLR
9
8
7
NXT
PRV