20
5 UNPACKING
Let the equipment acclimatize inside the closed box for at least one hour at the location where the
Oilcon
®
Oil Discharge Monitoring and Control System will be installed.
When the equipment is taken out of the box, please leave the special protection supplied with the
equipment as long as possible in place to avoid any damage.
Disposal of the packaging material should be done according to local laws or regulations, or
according to the rules that are applicable on the vessel.
Details of main components of the Oilcon
®
Oil Discharge Monitoring and Control System:
Main Control Unit (MCU)
Weight: 1.5 kg
Dimensions: 257 mm x 157 mm x 126 mm (W x H x D)
Figure 3: Main Control Unit
Electro Pneumatic Unit (EPU)
Weight: 9.5 kg
Dimensions: 500 mm x 263 mm x 114 mm (W x H x D)
Figure 4: Electro Pneumatic Unit
Motor Starter Box
Weight: 1 kg
Dimensions: 126 mm x 176 mm x 100 mm (W x H x D)
Figure 5: Starterbox
Electronic Differential Pressure Transmitter (DP/I)
Weight: 8 kg
Dimensions: 225 mm x 195 mm x 194 mm (W x H x D)
Figure 6: Electronic Differential Pressure
Transmitter
To Next Page
Loading...