VAF instruments OILCON MARK 6M - Overview Installation Check; Cable Connection Main Control Unit; Cable Connection Electric Pneumatic Unit

37
6.8 OVERVIEW INSTALLATION CHECK
6.8.1 Cable connection Main Control Unit
Reference drawings
 Electrical connection diagram Ballast Monitor Mark 6M MEPC 108(49) 0806-2048
 Connection diagram Oilcon Mark 6 Cable spec. MEPC 108(49) 0806-2050
E
D
Screen and tension clamp (see Figure 10):
 The cable must be stripped up to point D
 The stripped cable must be inserted in the clamp
 The cable must by tightened by using screw E
Signal cable (see Figure 11)
6.8.2 Cable connection Electric Pneumatic Unit
Reference drawings
 Control drawing for Mark 6M Oil Discharge Monitor 0806-0005
 Electrical connection diagram Ballast Monitor Mark 6M MEPC 108(49) 0806-2048
G H I J K L
G
H
I
J
K
L
Power supply cable IC-07
Signal cable IC-03
Starter box sample pump cable IC-06
Connection cable EPU Skid IC-02
Overboard Flowmeter-1 IC-04
Overboard Flowmeter-2(
if applicable) IC-04
Figure 12
Figure 11 Figure 10