46
In the different menus the following keys are available:
Navigation Operations
BACK Previous menu
SAMPLE Start sampling operations
UP Scroll up
STOP Stop sampling operations
DOWN Scroll down
FLUSH Start flush sequence
PRV Previous screen
W WASH Start windows wash sequence
NXT Next screen
+ Next setting
- Previous setting
Menus Action
? Information screen
OK Ok
BUZZER Buzzer test
CLR Clear
CHANGE Extended setup mode
A Automatic
CONFIG Configuration menu
ACK Acknowledge
DATA Data menu
PRINTER Printer menu
SELFTEST Self test menu
SETUP Setup menu
USB USB menu
MORE Next screen
With these keys it is possible to navigate through the different menus and change settings.
In the following sections, with a step by step walkthrough, is explained how to configure the MCU
and how menus are to be used.
In the top left corner of the display, the current mode is displayed.
Figure 34
CONTROL Sample point: 1 22-11-11
standby Oil type: 5 10:38
Concentration A 0 PPM discharge
Flow A 0 m3/h dirty
Skid Flow 0 l/h com: C
Speed A 10.0 kts pos: C
Discharge rate 0.0 l/nm segregated
Total oil 0.0 l com: C
Latitude 5321.756N pos: C
Longitude 00711.854E
EPU: OK
free: 1927296 kB
SETUP? DATA SELFTESTCONFIG
To Next Page
Loading...