66
Press the SETUP key to enter the setup mode.
Check if all parameter in the setup are correct and change them if necessary.
o Sample point 1…6
o Discharge mode clean ballast/dirty ballast
o Total oil limit 0…40,000 l
o Reset total oil Yes/No
o Discharge alarm 0…30 l/nm
o Speed indication automatic/0…40 knots
o Flowrate indication automatic/0…32,000 m³/h
o Oil type 0…31
o Concentration alarm 0…1,000 ppm
o Printing interval 1…10 min
o Oil concentration indication automatic/0…1,000 ppm
o Display contrast 710…790
o Date/time
Press the FLUSH key to enter the setup mode and initiate the calibration flush sequence.
o The valve V10 in the skid, opens to select clean water.
o The valve V11 closes.
o The selected sample valve opens.
o The sample pump starts.
o After 2 minutes of back flush a 12 second window wash is performed and the forward
flush starts.
o The valve V11 opens.
o The window wash pump (V12) operates for 12 seconds
o After 2 minutes of forward flush, the system changes to idle mode.
o The valve V10 closes.
o The selected sample valve closes.
o The sample pump stops.
Start the CARGO PUMP on idle speed.
Press the SAMPLE key to continue monitoring and to enter the sample mode.
The display changes to sample mode and the sample pump starts.
The monitor is now sampling from the selected sample point and will supply a readout of the
measured oil content level. Provided no alarms are activated and after a short delay, 20 s or 2 min
after an alarm situation is cleared, the overboard valve command will change to “OPEN”. This is
indicated in the display by “COM: O”.
Figure 60
The overboard discharge will now automatically be diverted overboard.
CONTROL Sample point: 1 22-11-11
sample Oil type: 5 10:38
Concentration A 200 PPM discharge
Flow A 165 m3/h dirty
Skid Flow 0 l/h com: O
Speed A 10.0 kts pos: O
Discharge rate 3.3 l/nm segregated
Total oil 2.1 l com: C
Latitude 5321.756N pos: C
Longitude 00711.854E
EPU: OK
free: 1927296 kB
MORE? CHANGESELFTEST
To Next Page
Loading...