Vaisala CL31 - Data Messages

USER'S GUIDE____________________________________________________________________
60 __________________________________________________________________ M210482EN-D
Command Description
set message type msg1_base Sets Msg1 without a profile.
set message type msg2_10x770 Sets Msg2 with 10x770 profile.
set message type msg2_20x385 Sets Msg2 with 20x385 profile.
set message type msg2_ 5x1500 Sets Msg2 with 5x1500 profile.
set message type msg2_ 5x770 Sets Msg2 with 5x770 profile.
set message type msg2_base Sets Msg2 without a profile.
set message type status Sets status message.
set message type ct25k_msg1 Sets CT25K message 1.
set message type ct25k_msg6 Sets CT25K msg6 / CT25KAM msg60.
set message type ct25k_msg61 Sets CT25KAM msg61.
set message type ct12k_dmsg2 Set CT12K message no. 2.
set message type ct12k_dmsg3 Set CT12K message no. 3.
set message type ld40_std_tg Sets LD40 Standard Telegram.
set modem v21 answer Sets modem to answer with v21.
set modem v21 originate Sets modem to call with v21.
set modem v22 answer Sets modem to answer with v22.
set modem v22 originate Sets modem to call with v22.
set modem v22bis answer Sets modem to answer with v22bis.
set modem v22bis originate Sets modem to call with v22bis.
set modem off Disables the communication module and uses serial
line communication.
set name <string> Sets the unit name.
set oper_mode standby Sets standby mode. Profile sampling is inactive.
set oper_mode normal Sets normal operation.
set port_timeout 0 ... 30 Sets the command line time-out to 0 ... 30 minutes.
Zero disables.
set unit_id <character> Sets the unit ID.
status Prints the status message.
system Lists system information: type, ID, SW version, HW
modules, serial number.
version Displays the SW version.
Table 9 Advanced Level Commands
Command Description
back Go back one security level. Go back to the user level
commands.
get failure diag Show failure diagnostics data.
get params algorithm Prints cloud algorithm related parameters.
service replace_instr battery Prints service instructions for replacing a battery.
service replace_instr cle_engine_board Prints service instructions for replacing a CLE321
engine board.
service replace_instr clp_ac_power Prints service instructions for replacing a CLP311
power unit.
service replace_instr clr_receiver Prints service instructions for replacing a CLR321
receiver.
service replace_instr clt_transmitter Prints service instructions for replacing a CLT321
transmitter.
service self_check Runs the self-check.
service spare_part cle_engine mark Marks CLE spare part status.
service spare_part cle_engine clear Clears CLE spare part status.
service spare_part clt_transmitter mark Marks CLT spare part status.
service spare_part clt_transmitter clear Clears CLT spare part status.
service spare_part show_state Shows spare part status of CLE and CLT.