USER'S GUIDE____________________________________________________________________
70 __________________________________________________________________ M210482EN-D
CL31 Status Message
The Status message displays the internal monitoring of the entire unit. It
is mainly meant for testing and maintenance purposes. The Status
message can be displayed by giving the
status command.
An example of the status message is presented below:
CL0100S0
10 00850 ///// ///// 000000000080
Alarms
Tmit Shutoff OK Transmitter OK
Receiver OK Voltages OK
Ext Memory OK Light Pth Obs OK
Rec Saturat OK Coaxial Cable OK
Engine OK
Oper Mode: normal Autoadj: on
Meas Mode: standard Interval: 2.0 s
Power Save: disabled Sleep Int: 60 s
Transmitter Receiver
Pulse Len: long Gain: high
Inlaser: 1745 Bandwidth: narrow
Pulse Cnt: 16384 Smpl Rate: 15 MHz
Pulse Frq: 10.0 kHz
Window Cnd: 100 % Outlaser: 1064
Backg Rad: 2.4 103 %
Tilt Angle: 0.4 Humidity: N/A
Temperatures
Internal: 23.7 External: 8.7
DC Power: 22.6 Inclinom: 28.9
Laser: 25.6 Blower: 8.3
Internal heater: off (auto)
Blower: on (auto)
Blower heater: on
Batt Use: off
System Status: OK
Suspect Module: none
To Next Page
Loading...
Need help?
General
