Vaisala CL31 - Functional Description

USER'S GUIDE____________________________________________________________________
42 __________________________________________________________________ M210482EN-D
Factory Settings of User Programmable
Parameters
Table 6 below lists the factory defaults of user-programmable
parameters. The prevailing parameter settings of Ceilometer CL31 can be
seen with the following command:
get params parameter_group
The user-programmable parameters can be changed with the following
command:
set parameter_group parameter
Table 6 Factory Defaults of User-Programmable Parameters
Parameter Factory Default
Control blower Auto
Control inheater Auto
Data_acq power_save Disabled
Data_port baud 19200
Data_port mode RS232
Data_port parity 8N1
Maint_port baud 9600
Maint_port parity 8N1
Message angle_corr On
Message transmission Periodic
Message transmission delay 100 ms
Message height_offset 0
Message interval 2 s
Message port Data
Message profile scale 1.0
Message profile noise h2 Off
Message type msg2_20x385
Message units Feet
Message vv_limit ceiling 2000 m (6562 ft)
Oper_mode Normal
Port_timeout 2 min
Unit_id 0 (zero)