Recommendations
• Continuous use over high operating voltage may cause heating. To conserve power and
minimize the warming of the probe, use the lowest operating voltage in the allowed
range.
• Using low impedance loads on the signal outputs increase the current consumption by up
to 0.5 mA. High impedance loads are recommended to minimize warming of the probe.
• Frequent interrogation of the probe using the RS-485 interface will also increase current
consumption from the average value. More frequent interrogation than once per second is
not recommended.
HMP60 and HMP110 Series User Guide M211060EN-J
28
To Next Page
Loading...
Need help?
General
