Valeo REVO-E - Page 3

2
REVO-E Heat pump Content
5.3 Malfunctions in the electrical system 501
5.4 Table of error codes 503
5.5 Error codes 504
5.6 Inspecting functionality of individual components 509
5.6.1 General visual inspection 509
5.7 Diagnosing the REVO-E units using the Diagnosis Control Test – DCT diagnostic software 509
5.8 Diagnosing the frequency converter 509
6 Wiring diagrams
6.1 Electrical fuses 601
6.2 Wiring diagram REVO-E HP (11120816*) 601
6.3 Wiring diagram REVO-E HP+ (11123865*) 608
6.4 Frequency converter - electrical connections 615
6.4.1 600V DC power supply including HVIL connector 615
6.4.2 400V AC voltage output 616
6.4.3 PE connection (potential equalizing) 616
6.5 Compressor - electrical connections 617
6.5.1 400V AC voltage supply 617
6.5.2 PE connection (potential equalizing) 617
7 Maintenance
7.1 Safety information 701
7.2 Versions of ADA 701
7.3 Maintenance and upkeep 701
7.4 Inspection and maintenance 701
7.4.1 Changing the fresh air filter 701
7.4.2 Changing the filter dryer 701
7.4.3 Inspecting the oil level of the compressor 702
7.4.4 Changing the compressor oil 702
8 Removal and installation of components (high-voltage system)
8.1 Safety information 801
8.2 Versions of ADA 801
8.3 Preparation/follow-up 801
8.3.1 High-voltage system 801
8.3.2 Refrigeration section 801
8.4 Frequency converter removal/ installation 802
8.4.1 Remove the frequency converter 802
8.3.2 Install the frequency converter 803
8.4 Refrigerant compressor removal/ installation 804
8.4.1 Remove the compressor 804
8.4.2 Comparing the old/new oil level 806
8.4.3 Install the compressor 806
8.5 600V DC/ 400V AC high-voltage cable removal/ installation 808
8.5.1 Remove the 600V AC cable 808
8.5.2 Install the 600V DC cable 808
8.5.3 Remove the 400V AC cable 808
8.5.4 Install the 400V AC cable 809
9 Removal and installation of components
9.1 Safety information 901
9.2 Versions of ADA 901
9.3 Preparation/follow-up 901
9.4 Condenser module removal/ installation 901