3
REVO-E Heat pump Content
9.4.1 Removal of the condenser module 901
9.3.2 Installation of the condenser module 902
9.4 Expansion valves removal/ installation 903
9.4.1 Positions of the expansion valves and the associated contact sensors 903
9.4.2 Remove an expansion valve 904
9.4.3 Install an expansion valve 904
9.5 Filter dryer removal/ installation 905
9.5.1 Remove the filter dryer 905
9.5.2 Install the filter dryer 905
9.6 Receiver removal/ installation 905
9.6.1 Remove the receiver 905
9.6.2 Install the receiver 905
9.7 Double radial blowers / axial fans removal/ installation 906
9.7.1 Remove a double radial blower 906
9.7.2 Install a double radial blower 906
9.7.3 Remove an axial fan 906
9.7.4 Install an axial fan 906
9.8 Recirculating air flap actuator motor removal/ installation 907
9.8.1 Remove the actuator motor 907
9.8.2 Install the actuator motor 907
9.9 Temperature sensor (duct / recirculating air suction) removal/ installation 907
9.9.1 Remove the duct temperature sensor (blow-out temperature) 907
9.9.2 Install the duct temperature sensor (blow-out temperature) 907
9.9.3 Remove the recirculating air suction temperature sensor (passenger compartment) 907
9.9.4 Install the recirculating air suction temperature sensor (passenger compartment) 907
9.10 Suction pressure sensor removal/ installation 908
9.10.1 Remove the suction pressure sensor 908
9.10.2 Install the suction pressure sensor 908
9.11 High-pressure sensor removal/ installation 908
9.11.1 Remove the high-pressure sensor 908
9.11.2 Install the high-pressure sensor 908
9.12 Pressure switch removal/ installation 909
9.12.1 Remove the pressure switch 909
9.12.2 Install the pressure switch 909
9.13 Compressor suction and pressure lines removal/ installation 909
9.13.1 Remove the pressure line 909
9.13.2 Install the pressure line 909
9.13.3 Remove the suction line 909
9.13.4 Install the suction line 909
9.14 Solenoid valve removal/ installation 910
9.14.1 Remove the coil 910
9.14.2 Install the coil 910
9.14.3 Remove the screw-in valve 910
9.14.4 Install the screw-in valve 910
Attachment A
Torque values/ seales A-1
To Next Page
Loading...
