VAMP 210 Generator protection relay
Operation and configuration
VAMP Ltd
10
Vamp 24h support phone: +358 (0)20 753 3264 VM210.EN004
3. Local panel operations
The local panel can be used to read measured values, to set
parameters and to configure relay functions. Some parameters,
however, can only be set by means of a PC connected to one of
the local communication ports. Some parameters are factory
set.
3.1. Navigation in the menus
All menu functions are based on the main menu / submenu
structure:
1. Use the arrow keys UP and DOWN to move up and down in
the main menu.
2. For moving to a submenu, repeatedly push the RIGHT key
until the required submenu is shown. Correspondingly,
push the LEFT key to cancel the selection.
3. Push the ENTER key to confirm the selected submenu.
4. Push the CANCEL key to cancel a selection.
5. Pushing the UP or DOWN key in any position of a submenu
will bring you directly one step up or down in the main
menu.
The active main menu selection is indicated with a small
triangular cursor sliding along the vertical line to the right of
the main menu column. The possible navigating directions in
each part of the menu are shown in the upper left corner by
means of the black triangular symbols.
To Next Page
Loading...
Need help?
General
