VAMP 210 - Setting Protection Function Parameters; Configuration Menu CONF

VAMP 210 Generator protection relay
Operation and configuration
VAMP Ltd
26
Vamp 24h support phone: +358 (0)20 753 3264 VM210.EN004
5.6. Setting protection function parameters
The settings of the selected protection functions can be read
and set separately in the submenus of each function.
Available Protection stages
• I>, I>>
• I
V
>
• I
2
>
• I
0
>, I
0
>>
• I
0
ϕ
• I
02
>, I
02
>>
• U
0
>, U
0
>>
• U>, U>>
• U
1
<, U
1
<<
• T>
• Q<
• P<, P<<
• f>, f>>
• f<, f<<
• ArcI>, ArcIo>, ArcIo2>
• CBFP
5.7. Configuration menu CONF
Via the submenus of the configuration menu the following
functions and features can be read and set:
DEVICE SETUP
• Transfer rate of local serial bus (bit/s)
• “AccessLevel” display (Acc)
POWER SCALING
• Rated generator apparent power (Sgn)
• Rated generator voltage (Ugn)
• Rated generator current (Ign) (derived value)
• Prime mover shaft power (Pm)
• Calculated power CTxVT (CTxVT) (derived value)
• Unit transformer used? (Trafo)